Dimensions I’ve drawn on it are in inches. So along the thick inside seam of the goggle back of the minion, place a bit of glue at a top and glue the edges of this circular piece of fabric until it’s all sealed off.Ĭut a piece of cardboard as follows. We’re going to use this piece of fabric to seal off the top of the head, keeping the stuffing up there. Turn the minion on its head and flip inside out. Once done, it should look like this with a nice smooth edge.Ĭut a round piece of black fabric, just slightly wider than the head of the minion itself. Be careful not to use big globs of glue as it will show on the outside. On the inside of the triangular flaps on the front, spread glue thinly and evenly, and then fold back and glue to inside of minion. Once you made the cut above, hollow out the minion of all stuffing except for the stuffing in the arms and the top of the head (about from the goggle band upwards). We’re going to do a vertical cut starting about 4 inches down from the black band around the head, and down to right in between the legs. ![]() We’re not going to cut the triangular flaps off, but instead we will later glue them to the inside to create a soft edging around the hole – and to prevent it from fraying or looking messy.Ĭut off the feet of the minion, just above the point where the blue fabric meets the yellow fabric of the feet. This is what it should look like once you cut along those lines. We’re going to do a pie-cut, so draw lines like this that we’ll cut along. The circumference of the circle you cut should be just bigger than the vertical circumference of your dog’s head. We want to cut a hole in the front of the face just below the minion’s goggles for the dog’s face.
0 Comments
Leave a Reply. |